emtbd1979
4-H er
Hooray for boobies!
Posts: 37
|
Post by emtbd1979 on May 13, 2012 21:32:23 GMT -5
I have an 03 3600 and sometimes when I lower a marker the marker in the rack will raise halfway up also.there doesn't seem to be any consistency of which marker will do it or when, it may work fine for a few hours and then throw a fit for a couple rounds. Anyone know what might be the culprit?
|
|
|
|
Post by Topshot on May 16, 2012 21:34:46 GMT -5
Don't know that this has anything to do with your problem, but I had a problem with ours blowing a fuse once in a while when the left marker was used. Couldn't figure it out for a long time until I looked really closely where all the wires run up the vertical post (the part where the wires are held to keep them out of everything when the planter is raised and lowered for transport) and are clamped to it in a couple of spots. One of those places had rubbed through the insulation and would short out periodically. Could just barely see it on inspection. Maybe you have a wire or two rubbed bare in that same general area and it activates the wrong solenoid at times. Worth a look at least.
|
|
|
|
Post by acfarmer on May 18, 2012 23:25:50 GMT -5
Just curious . Have you flipped the toggle and lowered the one that came up in the rack and the one on the ground stayed on the ground?
|
|
emtbd1979
4-H er
Hooray for boobies!
Posts: 37
|
Post by emtbd1979 on May 20, 2012 12:26:11 GMT -5
Yes, when I lower the one in the rack the other marker that is down will come up a little also, so you have to switch the toggle back to the marker you want to use to put it back in the dirt.
|
|
|
|
Post by acfarmer on May 20, 2012 19:48:09 GMT -5
Im going to guess there is something screwy going on in the valve body on the markers. A blowed O-ring letting fluid to the other side
|
|
